AVANT GARDE'N

When trying to remotely control large amperage equipment such as air conditioners or heavy-duty fans, you need a device like the HAC-30A. The HAC-30A makes it simple to control up to 30-amp @ 240 volt devices from a single timer or controller.

An internal heavy-duty relay inside the HAC-30 is turned On and Off by connecting the 15 ft "trigger cable" to any 120volt controller like the EVC or CHHC. When the controller turns ON, the trigger cable caries the voltage to the relay inside the HAC-30A, the relay activates, and the device connected to the HAC-30A is energized.

Think of the HAC as a remote high amperage switch. The HAC-30A is housed in a sealed, aluminum heat sink enclosure and can be mounted using the wall mount bracket included. The user must connect a 240 volt, up to 30 amp circuit to the HAC-30A.

* Some simple wiring is required.

• HPR-1 is hard wired 30 Amp capacity, 240V power relay



• controls multiple lights up to 30 Amps



• Supply 240 volts to input side of the relay



• Hard wire appliances to into the output side of the relay



• 16 Ft trigger cable coming from the HPR-1 is then connected to time clock, thermostat, or controller



• 3-year rebuild or replace warranty

DC Adapter 120 Vac - 12 Vdc, All iGS Controllers   

The UPM-1 allows the user to run additional HID lights or control multiple fans/air conditioners or other high amperage 120 volt equipment.